NOTE
The submodules “Digital input” and “Digital output” for the IO-Link Device ports (Slot 2,
Subslots 2…5) don’t have any start-up records.
The parameters are defined as follows:
Parameter Definition
GDIAG (Global diagnostics) Function “Global diagnostics” (see "Global diagnostics",
page 32)
PCM (Port configuration mode) Function “Port configuration mode” (see "Port configuration
mode", page 32)
Validation and Backup Function “Inspection Level”
Expected Vendor ID Function “Expected Vendor ID” (see "Expected Vendor ID",
page 33)
Expected Device ID Function “Expected Device ID” (see "Expected Device ID",
page 34)
Port cycle time Function “Port cycle time” (see "Port cycle time", page 34)
7.1.2.1.2.2 I&M Data
SIG200 supports PROFINET identification and maintenance (I&M) data. The records
I&M0, 1, 2, and 3 are implemented.
7.1.2.1.2.3 Record data
The following records are available in SIG200 PROFINET for acyclic access during oper‐
ation.
NOTE
The index range is from 0….65535 but there are special and reserved ranges.
SIG200 IO-Link Master Record Data (Slot 2, Subslot 1)
Function name Index Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
IO-Link Master
info
45056
(0xB00
0)
0 Block major version number (“1”)
1 Block minor version number (“0”)
4 Port count (“4”)
5 Client access point (“0xB400”)
6
Consolidated
port configura‐
tion
45312
(0xB10
0)
45313
(0xB10
1)
45314
(0xB10
2)
45315
(0xB10
3)
0 Block major version number (“1”)
1 Block minor version number (“0”)
4 0 0 0 0 PCM 0 0
5 Validation and Backup
6 Expected Vendor ID
7
8 Expected Device ID
9
10
11
12 Port cycle time
13 Input data length
14 Output data length
7 SIG200 CONFIGURATION
28
O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200 8017853/2019-06-06 | SICK
Subject to change without notice
To Next Page
Loading...
