SICK TR110 Lock

5.3 Mounting the safety switch
Important information
NOTICE
The actuator must not be used for guiding or used as a stop.
Prerequisites
•
To mount on the machine, the safety switch and actuator must be put together.
•
A clearance of 12 mm must be maintained around the actuating head.
Approach
The safety locking device may be in any installation position.
b
Mount the safety switch using 4 × M5 screws.
b
Observe the maximum tightening torque of 1.4 Nm.



Figure 18: Mounting the safety switch
1
Mounting holes
2
12 mm clearance for actuator
Complementary information
Mounting brackets are available for the actuator and safety locking device as acces‐
sories (see "Dimensional drawings of the mounting bracket", page 60).
5.4 Mounting straight and angled actuators
Important information
NOTICE
The actuator must not be used for guiding or used as a stop.
MOUNTING 5
8023119/15LY/2019-10-28 | SICK O P E R A T I N G I N S T R U C T I O N S | TR110 Lock
25
Subject to change without notice