SICK TR110 Lock

11 Technical data
11.1 Data sheet
Table 15: Features
Features
Sensor principle Transponder
Coding Uniquely coded
Locking force F
max
With straight TR110-XAS actuator 3,900 N (EN ISO 14119)
With angled TR110-XABT actuator 1,500 N (EN ISO 14119)
With TR110-XAFx hinged actuator 2,600 N (EN ISO 14119)
Retaining force F
Zh
(F
Zh
= F
max
/1.3)
With straight TR110-XAS actuator 300 N (EN ISO 14119)
With angled TR110-XABT actuator 1,100 N (EN ISO 14119)
With TR110-XAFx hinged actuator 2,000 N (EN ISO 14119)
Actuating force 10 N
Retaining force 20 N
Force against which unlocking is possible ≤ 20 N
Actuating frequency ≤ 0.5 Hz
Starting speed ≤ 20 m/min
Overrun 5 mm
Table 16: Safety-related parameters
Safety-related parameters
Performance level
1)
PL e (EN ISO 13849-1)
Category
1)
4 (EN ISO 13849-1)
PFHd
2)
(mean probability of a dangerous fail‐
ure per hour)
4.1 × 10
–9
T
M
(mission time) 20 years (EN ISO 13849–1)
Type Type 4 (EN ISO 14119)
Coding level High coding level (EN ISO 14119)
Safe status when a fault occurs At least one safety-related semiconductor out‐
put (OSSD) is in the OFF state.
1)
Applies to monitoring the door position (interlocking monitoring) and locking monitoring.
2)
The locking solenoid is externally controlled and so does not contribute to the probability of failure. The
safety level of the locking device controller is determined exclusively by the external controller.
Table 17: Electrical data
Electrical data
Classification based on cULus Class 2
Protection class III (IEC 61140)
Utilization category DC-13: 24 V, 150 mA (IEC 60947-5-2)
Supply voltage U
V
Safety switches
Locking solenoid
1)
20.4 V DC … 27.6 V DC
20.4 V DC … 26.4 V DC
Current consumption
TECHNICAL DATA 11
8023119/15LY/2019-10-28 | SICK O P E R A T I N G I N S T R U C T I O N S | TR110 Lock
45
Subject to change without notice