Figure 38: Actuating the emergency release
1
Emergency release
2
Stop bolt
8.2.1 Moving the emergency release back after use
Approach
b
Push the stop bolt inward, e.g. with a small screwdriver.
b
Move the emergency release back to the following symbol:
b
Seal the emergency release.
b
Open the protective device and close it again.
✓
The safety locking device operates in normal mode again.
b
Carry out a functional test.
8.3 Actuating the escape release
Approach
1. Press the red button of the escape release as far as it goes.
✓
The locking device is unlocked.
8 OPERATION
40
O P E R A T I N G I N S T R U C T I O N S | TR110 Lock 8023119/15LY/2019-10-28 | SICK
Subject to change without notice
To Next Page
Loading...