sidhil Solite UK - 8.3 Fitting the Electrical System

14
8.3 Fitting the Electrical System
• Once all the cables are connected they
are to be secured in place by attaching
the supplied retaining clip.
• Clip the mains cable into the hook on the
head end section of the bed (the clip is
secured by twisting the ends together).
• Drive the bed to the maximum height
then secure the actuator cables in
the twist clips. Ensure each bed end
actuator cable has enough flex to allow
full movement of the actuator.
Note: The two bed ends are identical however plugging them into the correct
port is important. Note the location of the correct end before plugging in.
Mains cable clip
• Plug the actuator and handset cables into the control box. The control box has
a label showing the correct port into which the corresponding cable is inserted.
Note, the plugs only fit into the ports in one orientation. Ensure the cables are
plugged fully into the control box.
Head end actuator
Foot end actuator
Backrest actuator
Knee break actuator
Handset