28
13. DECONTAMINATION
• Alwaysdisconnectthebedfromthemainpowersupplypriorto
cleaning.
• Ensureallportsontheelectricalsystem(controlboxandactuators)
have cable plugs inserted to maintain the IP rating.
• Regularcleaninganddisinfectionofthebedframeandrelevant
accessories will help to prevent the risk of infection to the occupant
and / or carer.
• Priortotransferringthebedframe/accessorytoanotheruserensure
it has been cleaned and disinfected using the method as detailed below
to help prevent the risk of cross infection.
It is advisable to remove any accessories that are fastened to the bed.
These instructions apply to all accessories apart from soft products (e.g. mattresses).
• All surfaces should be wiped down with a disposable soft cloth moistened with a
milddetergentanddilutedinwarmwater(40°C).
• The bed should be cleaned by starting with the cleanest parts of the bed and
systematically moving to the dirtiest parts. Extra care should be taken around
areas where excess dirt or dust may gather.
• The cloth should be changed during the cleaning process if it becomes soiled.
• Rinse down with clean water to remove detergent residue.
• Wipesurfacesdownwith1,000partspermillionchlorinesolution(0.1%).
• Dry off with a paper towel.
• Always ensure the cleaned parts are allowed to dry before putting the mattress
back in place.
Note: If any of the 3 stages stated above (detergent, rinse down & chlorine solution)
are omitted or combined it will reduce the effectiveness of the clean.
In cases of blood spills or other bodily fluids it is recommended that a chlorine solution
of10,000partspermillion(1%)isusedinstead.Ensurefabricsurfacesarerinsedwith
clean water after application.
Note: The use of neat bleach or similar surface cleaners is not recommended as
damage may be caused to the cleaned surfaces.
Infection control and routine cleaning must be carried out in accordance with your
local Infection control policy or regulatory body.
13.1 Cleaning and Disinfection Guidelines
Warning