sidhil Solite UK - Assembly onto Transport Stand

25
10. ASSEMBLY ONTO THE TRANSPORT STAND
Electrics
• Flatten and lower the bed to its minimum height (see section 9.6) for operation
of the handset.
• Unplug the mains cable from the mains socket.
• Using a flat bladed screwdriver remove the retaining clip from the control box.
• Unplug the high / low and leg section actuator cables from the control box.
Bed Frame
• Release transport stands from their under bed storage brackets.
• Release the brakes from the castors.
• Loosen the hand wheels in the middle of the bed frame and remove the clevis pins,
‘R’ clips and spacers.
• Whilst supporting both halves of the bed frame, split the bed in half and gently
lower onto the floor.
• Unlock both locking collars on one end (collar must be lifted before turning).
• Whilst supporting the bed end, lift the platform away and gently position both
sections on the floor / against a wall.
• Repeat for the remaining half of the bed.
• Using the 2 orange hook and loop straps that first came with the bed, secure the
moving parts of the backrest and leg section to the bed frame halves.
Warning
• Beforeattemptingtoassemblethebedontothetransportstand 
ensure these instructions have been read and fully understood.
• Itisadvisabletoassemblethebedwithasecondablebodiedperson.
• Takecarewhenassemblingthebedontothetransportstand,the 
sections are of considerable weight.