EasyManua.ls Logo

sidhil Solite UK - 17.1 Mattress; Side Rail Compatibility Chart

Default Icon
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
37
17.1 Mattress / Side Rail Compatibility Chart
GRANGE/
SR
UNIVERSAL/
SR/MAG
UNIVERSAL/
SR/HI/MAG
SOLITE/
SR/2
Acclaim VE MAT/ACCL/VE/W
ü ü ü ü
Acclaim Profiler MAT/ACCL/PRO/W
ü ü ü ü
Softrest VE MAT/SOFT/VE
ü ü ü ü
Softrest Contour MAT/SOFT/CON
ü ü ü ü
Essential Foam MAT/BASIC
ü ü ü ü
Trio II DYN/DIG/TRIO/2 - -
ü
-
Plus II DYN/DIG/PLUS/2 - -
ü
-
SoloXtra DYN/DIG/SOLO/XTR
ü* ü ü ü
Solo II
Softrest Thin
DYN/DIG/SOLO/2
MAT/SOFT/THIN
ü** ü ü ü
Standard grab handle 1210/GRAB
ü*** ü ü
-
‘Safe side’ grab handle 1213/GRAB - - -
ü
Short grab handle 1216/GRAB
ü ü ü
-
Padded Side 1316/PS/CREAM
ü ü
- -
Padded Side 1316/PS/UNIVERSAL - -
ü
-
* Sidhil Ltd deems the SoloXtra dynamic mattress to be suitable for
use with the Grange side rail, however it is approximately 10mm out of
compliance in relation to the 220mm dimensional requirement between
thetopoftheuncompressedmattressandthetopofthesiderail-Itis
essential that a patient risk assessment is performed to ensure that this
does not introduce a hazard to the patient.
**SidhilrecommendssettingthepressureoftheSoloIIdynamicmattress
between medium and high, if set on a lower pressure setting there is a
small probability that the gap between the Grange side rail and mattress
willintroduceahazard-Itisessentialthatapatientriskassessmentis
performed to ensure that this does not introduce an unacceptable risk.
***Caremustbetakenwhenraisingthebackrestwhenusedinconjunction
with the 1210/GRAB, as the gap between the two components can
become less than 25mm in certain situations.
Warning
Sidhilcannotbeheldresponsibleforanyinjuryorincidentwhichrelatestotheuseof
any product combinations not approved by Sidhil Ltd.
It is the carer’s responsibility for selecting and fitting the products correctly and
ensuring that the product combination is compatible.