Siemens 8DA - 5.3 Storing Transport Units

fåëí~ää~íáçå
8 oÉîáëáçå=MP=G=fkpq^iiqflk=fkpqor`qflkp=Ua^=G=USNJVOTPKV=
Floor openings and fixing
points
Floor fixing Recommendation: A base frame to fasten the panels on should be prepared in the floor
of the switchgear room. The panels can be bolted or welded to the base frame.
Fig. 3: Floor opening and fixing points
1 Base frame
2 Floor opening for
control cables
(Standard)
3 Floor opening for
control cables (end
panels)
4 Floor opening for
control cables (gir-
der on panel width)
5 Floor opening for
high-voltage
cables
6 Fixing points
7 External edge of
switchgear
Fig. 4: Base frame
a
Standing surface