V1.0
28
Assemble the C35
STEP 1:
Check that the Lower Housing Assembly, Control Board Assembly and Upper Housing
Assembly are in good order. Check if the Buzzer sealing was installed on the Control Board.
New Upper and Lower Casing must be used. All
contact pins must not be dirty, damaged or bent!
If any part is not O.K please replace it with a new
part.
STEP 2:
Place the Control Board Assembly in the Lower Housing Assembly and then place the keypad
on top of the Control Board as illustrated in PHOTO 2.15. You may insert a battery in this step to
test that the phone can be switch on.
PHOTO 2.15 ASSEMBLE C35 – STEP 2
1