EasyManuals Logo

Siemens CP 343-1 Lean User Manual

Siemens CP 343-1 Lean
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
Notes on configuration and operation
6.3 Network settings
CP 343-1 Lean
38 Manual, 10/2012, C79000−G8976−C198−07
Module access protection
The configurable module access protection has the following effects on the functions
described here:
Module access protection: Not locked
The functions cannot be executed.
Module access protection: Status-dependent
With this setting, it is only possible to access the CP when the CPU is in STOP mode.
6.3 Network settings
The configuration of the network settings "Transmission medium / Duplex" is made in the
properties dialog of the port of the interface in the "Options" tab.
Row "X1P1": Properties of port 1 of the PROFINET interface
Row "X1P2": Properties of port 2 of the PROFINET interface
Automatic setting or individual network settings
As default, the CP is configured for automatic detection (autosensing / autonegotiation /
autocrossing).
Note
In normal situations, the basic setting ensures troublefree communication. You should only
change this in exceptional situations.
If you create a manual configuration for the CP, the automatic negotiation of the network
settings (autonegotiation) is no longer effective. If, on the other hand, the communication
partner works with autonegotiation, no communication will be established.
Only use manual configuration when the communication partner works with the same
manually set configuration.
Autocrossing mechanism
The automatic setting also includes an "autocrossing" mechanism. With autocrossing, you
can connect network components and end devices using either crossover or straight-through
cables.
STEP 7 special diagnostics and Web diagnostics display the network setting
Diagnostics of the port settings for the CP described here is possible using the entries in the
diagnostics buffer using Web diagnostics, SNMP, STEP 7 diagnostics, and the LED
displays.
You will find information on the currently used network settings in STEP 7 as follows:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens CP 343-1 Lean and is the answer not in the manual?

Siemens CP 343-1 Lean Specifications

General IconGeneral
BrandSiemens
ModelCP 343-1 Lean
CategorySwitch
LanguageEnglish

Related product manuals