EasyManuals Logo

Siemens CP 343-1 Lean User Manual

Siemens CP 343-1 Lean
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
Service and maintenance
7.3 Replacing a module
CP 343-1 Lean
Manual, 10/2012, C79000−G8976−C198−07
49
If the loading with the firmware loader is interrupted, you should react as follows:
Disturbances or collisions on the network can lead to packets being lost. In such cases, this
can lead to an interruption of the firmware download. The firmware loader then signals a
timeout or negative response from the module being loaded.
In this case, turn the station off and on again and repeat the download.
7.3 Replacing a module
Note
Recommendation to reset address data if the use of the CP is changed
The following data is stored permanently on the CP:
IP parameters when using DHCP
If the CP has already been operated in your plant and you want to use it at a different
location in the plant, it starts up with the permanently configured parameters.
If the CP has been used previously in your plant or has been repaired, delete all stored data
by resetting to the factory settings.
7.3.1 Replacing older modules
Distinction
When replacing existing modules with the module described here, the following variants
must be distinguished:
Replacing a module
Describes the situation when an existing module can be replaced with a new module
simply by pulling/plugging without changing the configuration.
Upgrading
(module replacement with compatible functions)
Describes the situation when the module described here can be used instead of an older
module as long as adaptations are made to the configuration. Here, the previously used
CP needs to be replaced in the configuration by the new CP.
Unless otherwise specified, the range of functions of the older module continues to be
supported.
You can also upgrade modules listed in "Module replacement". This is necessary when new
characteristics that were not available in the previously used module are required.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens CP 343-1 Lean and is the answer not in the manual?

Siemens CP 343-1 Lean Specifications

General IconGeneral
BrandSiemens
ModelCP 343-1 Lean
CategorySwitch
LanguageEnglish

Related product manuals