Approvals
CP 343-1 Lean
56 Manual, 10/2012, C79000−G8976−C198−07
● EC directive 94/9/EC "Equipment and protective systems intended for use in potentially
explosive atmospheres" (ATEX Explosion Protection Directive)
– EN 60079-0:2006: Potentially explosive atmosphere - general requirements
– EN 60079-15: 2005: Type of protection 'n'
● EC directive 2006/95/EEC "Electrical Equipment Designed for Use within Certain Voltage
Limits" (Low Voltage Equipment Directive)
– EN 61131–2 / IEC 61131–2 (programmable logic controllers, part 2: equipment
requirements and verifications)
The EC Declaration of Conformity is available for the responsible authorities according to the
above-mentioned EC Directive at the following address:
Siemens Aktiengesellschaft
Industry Automation
Industrielle Kommunikation SIMATIC NET
Postfach 4848
D-90327 Nürnberg
You will find the EC Declaration of Conformity for this product on the Internet at the following
address:
21687867 (http://support.automation.siemens.
com/WW/view/en/21687867)
→ "Entry list" tab
Filter settings: Entry type "Certificates", Certificate Type "Declaration of Conformity"
ATEX approval
WARNING
Installation guidelines
The product meets the requirements if you keep to the following during installation and
operation:
The notes in the section Installation, connecting up and commissioning (Page 29)
The install
ation instructions in the document /12/ (Page 62)
ATEX approval: II 3 G Ex nA II T4
Test number: KEMA 03ATEX1228 X
Relevant standards:
● EN 60079-0:2006: Potentially explosive atmosphere - general requirements
● EN 60079-15:2005: Electrical apparatus for explosive gas atmospheres; type of
protection 'n'
The device is suitable for use in environments with polution degree 2.
The device is suitable for use only in environments that meet the following conditions:
● Class I, Division 2, Group A, B, C, D and areas where there is no risk of explosion
● Class I, Zone 2, Group IIC and areas where there is no risk of explosion
To Next Page
Loading...
