Siemens CU230P-2 HVAC - 1.5 Quick commissioning (p0010 = 1)

Quick commissioning (p0010 = 1)
Parameters
1-431
© Siemens AG 2009 All Rights Reserved
SINAMICS G120 Control Units CU230P-2 Parameter Manual (LH9), 11/2009
1.5 Quick commissioning (p0010 = 1)
The following parameters are necessary for quick commissioning (p0010 = 1).
.
Table 1-4 Quick commissioning (p0010 = 1)
Par.-No. Name Access level Can be
changed
p0004 Display filter 1 C(1)UT
p0010 Drive commissioning parameter filter 1 C(1)T
p0100 *) IEC/NEMA mot stds 4 C(1)
p0205 Power unit application 1 C(1)
p0230 Drive filter type, motor side 3 C(1,2)
p0300 Motor type selection 2 C(1,3)
p0301 Motor code number selection 2 C(1,3)U
p0304 Rated motor voltage 1 C(1,3)
p0305 Rated motor current 1 C(1,3)
p0307 Rated motor power 1 C(1,3)
p0308 Rated motor power factor 1 C(1,3)
p0309 *) Rated motor efficiency 1 C(1,3)
p0310 Rated motor frequency 1 C(1,3)
p0311 Rated motor speed 1 C(1,3)
p0314 Motor pole pair number 3 C(1,3)
p0322 Maximum motor speed 1 C(1,3)
p0323 Maximum motor current 1 C(1,3)
p0335 Motor cooling type 2 C(1,3)T
p0500 Technology application 1 C(1,5)T
p0640 Current limit 1 C(1,3)UT
p0700 Command source selection 1 C(1)T
p0922 PROFIdrive telegram selection 1 C(1)T