Safety
General safety percautions
3
7
Siemens AG
A6V10334045
22.12.2011
3 Safety
3.1 General safety percautions
z Read the general safety precautions before installing/configuring/operating the
device.
z Follow all warnings and instructions marked on the device.
z Keep this document for reference purposes.
z This document must always accompany the product.
Liability claim
z Use only spare parts and accessories that have been approved by the
manufacturer.
3.2 Transport
z Keep the packaging material for future transportation.
z Do not expose the device to mechanical vibrations or shocks.
3.3 Installation
z It is recommended that all preparatory work (e.g. fitting of accessories) be
carried out in a workshop prior to final installation.
z The environmental conditions recommended by the manufacturer must be
observed. See section 'technical data'.
z Do not operate the device close to sources of powerful electromagnetic
radiation.
z The mounting surface must be solid and non-combustible.
Danger of electrical shock/fire hazard/damage to the device due to
incorrect connection
z Connect the device only to a power source that complies with SELV
requirements and with the Limited Power Source requirements to EN 60950-1.
3.4 Maintenance
z Do not attempt to service or modify this device yourself. Refer this work to
qualified service personnel.
z Do not use liquid cleaners or sprays that contain alcohol, spirit or ammonia.
3.5 Sensor characteristics
The following conditions may be observed when using a CMOS camera. These are
inherent in the design and do not stem from any fault in the camera itself.
z Vertical smear:
This phenomenon occurs when viewing a very bright object.
To Next Page
Loading...
