Siemens FDA2 1 Series Technical Manual

5
Mounting / Installation
Mounting
60
Building Technologies A6V10334410_h_en_--
Fire Safety 2015-09-29
4. Screw the four screws into the mounting holes.
– Do not screw in the screws as far as the stop. A gap of approx. 10 mm
must remain between the screw head and the wall.
5. Hang the back box on the screws.
6. Carefully tighten the four screws.
 The back box is fastened.
7. Reconnect the cable and close the housing cover.
 The aspirating smoke detector is installed.

Siemens FDA2 1 Series Specifications

General

Brand	Siemens
Model	FDA2 1 Series
Category	Smoke Alarm
Language	English