Building Technologies A6V10334410_h_en_--
Fire Safety 2015-09-29
Updating the firmware
The existing version of the firmware has been checked against the latest
version and needs to be updated.
The 'FXS2051 ASD Asyst Tool' software is running. The installed version can
be displayed on the 'Help' main menu under the 'About' menu.
1. Use the initial password '1234' or enter your own password.
2. Go to the 'Update' main menu and select the 'Update firmware' submenu or
use the keyboard shortcut <Ctrl> + <U> instead.
The firmware is updated.
The device time is reset automatically.
3. Update the device time.
The firmware update is complete.
Changing the configuration
The 'FXS2051 ASD Configuration Tool' software is running.
The first basic settings have been made on the 'FXS2051 ASD Configuration
Tool'.
1. Select the 'Connect' command in the contact bar to establish contact.
2. Use the initial password '123456' or enter your own password.
3. To upload parameters, select the 'Transfer parameters to PC' command in the
contact bar or use the keyboard shortcut <Ctrl> + <A> instead.
Data is uploaded from the aspirating smoke detector to the PC.
4. Change the settings to suit your requirements.
5. To download parameters, select the 'Transfer parameters to ASD' command in
the contact bar or use the keyboard shortcut <Ctrl> + <Y> instead.
Data is downloaded from the PC to the aspirating smoke detector.
The configuration has been changed.
To Next Page
Loading...
Need help?
General
