Siemens FIDAMAT 6 - Page 2

Compact Operating Instructions in accordance with EN 61010-1 and EN 60079-0
2 A5E45779144002-01, 09/2018
We are using the label of an ULTRAMAT 23 as an example.
1
Data matrix code
2
Disposal information: Do not dispose with household waste!
3
CE conformity symbol
4
Name and address of manufacturer
5
Designation of origin
6
Measuring range(s)
7
Serial number
8
Order No. (MLFB number) of the device
9
Device name
Figure 1-1 ULTRAMAT 23 label (example)
These Operating Instructions also cover the rack-mounted versions of Series 6 (CALOMAT 6E and ULTRAMAT 23)
approved for operation in hazardous areas in accordance with the EU directive 2014/34/EU (ATEX).
The following table provides an overview of the associated analyzers.
Table 1-1 Rack-mounted analyzers of Series 6 approved for operation in hazardous areas
Certificate
Ex type of protection
Device
MLFB No.
KEMA 09 ATEX 0027 X
Non-sparking
II 3G Ex ec ic nC IIC T4 Gc
ULTRAMAT 23
7MB233x-xxxxx-xxxx-Z-E20+xxx
7MB235x
TÜV 02 ATEX 1873 X
Hermetic seal
or
non-sparking
II 2/3 G Ex ec nC IIC T4 Gb/Gc
CALOMAT 6E 7MB252x-xxx00-xABx-Z+xxx
7MB252x-xxx01-xABx-Z+xxx
It is essential that you also observe the respective "Special conditions" of the certificates referred to in the table.
These describe
● The fields of application
● The requirements for operation in hazardous areas
● Other precautionary measures which are important for operation.
The technical specifications in these Operating Instructions may be different to those in the associated Operating
Instructions for the analyzers and additional equipment under some circumstances. The technical specifications listed in
these Operating Instructions are valid in such cases.