40
The configuration program
Gigaset WLAN Repeater/ englisch / A31008-E505-B105-1-7619 / basic_config.fm / 08.03.2004
If instead of the start page you see the error message "The page cannot be displayed":
u
Check that the address has been keyed in properly.
u
Make sure that your browser is not in offline mode.
u
Deactivate any other LAN connections of your computer.
u
Check the TCP/IP properties (see from page 20) and if necessary update the assign-
ment of IP addresses on your PC as described on page 99.
u
Make sure the JavaScript and the "popup" function are enabled in your browser set-
tings as the configuration program is opened in a popup window.
Login
After a few moments you will see the login screen.
The factory setting for the password is
admin
.
ì
Click on the entry box and enter
admin
.
ì
Click on OK.
Please remember:
u
If you have typed it wrongly, you will see an error message.
Enter the password correctly.
u
When you carry out Security Setup (see page 65), you can change the password.
You can also change the password at any time using Advanced Setup
(see page 75).
To Next Page
Loading...
Need help?
General