Hematek
®
3000 System – Instruction Manual – Version 1.3 13
3 Life cycle
This chapter describes the stages the system goes through, from delivery
to disposal, and the requirements involved for the operator with each stage.
3.1 Delivery
3.1.1 Unpacking and checking the delivery
To unpack and check the delivery, proceed as follows:
1. Before opening, check the transport container for signs of external
damage.
2. If the transport container shows any visible signs of damage,
immediately file a complaint with the carrier.
3. Open the transport container.
4. Carefully cut the straps securing the foam packing.
5. Remove all small single packages.
6. Remove the upper part of the foam packing.
7. Grasp the slide stainer from both sides under its frame where the foam
packing is cut out.
8. Carefully remove the slide stainer by lifting it by its frame.
9. Remove the plastic bag from the slide stainer.
10. Retain the transport container, plastic bag, and foam packing. If the
system needs to be transported, these will afford the best protection.
11. Check the content for completeness, see Chapter 3.1.2, and intact
condition.
12. If anything is missing or damaged, inform the Siemens service
immediately.
The straps securing the foam packing are highly tensioned and can
snap back when being cut
Minor or moderate injury can result.
• Use a suitable tool to cut the straps.
• Take special care while cutting the straps.
To Next Page
Loading...
