Siemens Hematek 3000 System - Installing the Underplaten Tubing

7 Performing maintenance
Hematek
®
3000 System – Instruction Manual – Version 1.3 137
7
7.4.2 Installing the underplaten tubing
You will need:
• 1 new Hematek Underplaten Tubing Set
To install the underplaten tubing, proceed as follows:
Connect tubes to nipples 1. On the middle panel, connect one of the new tubes of the underplaten
tubing to each nipple.
2. Make sure that at least 7mm (1/4 in) of each tube is connected to a
nipple.
Insert tubes into tube clamps 3. Open the tube clamps.
4. Insert the tubes into the tube clamps.
5. Close the tube clamps.
1 Middle panel
2 Nipples
3 Tube clamps
4 Rear conveyor spiral
Figure 7-7 Connecting the underplaten tubing to the nipples
3
1 2 2 2
34