Siemens Hematek 3000 System - System De-installation Process; System Transport Guidelines and Precautions

Hematek
®
3000 System – Instruction Manual – Version 1.383
3 Life cycle
3
Clean platen 10. Clean the platen, see Chapter 6.4.
Clean waste tank 11. Clean the waste tank, see Chapter 6.5.
Clean exterior surfaces 12. Clean the exterior surfaces, see Chapter 6.2.
3.4 De-installation
To de-install the system, proceed as follows:
1. Prepare the system for non-operation, see Chapter 3.3.
2. If you want to store the system, make sure that the storage location
meets the storage and transportation conditions, see Environmental on
page 9-3.
3.5 Transport
To transport the system, proceed as follows:
1. Prepare the system for non-operation, see Chapter 3.3.
2. Screw the two leveling feet at the front all the way up.
Note: Always transport or ship the system in the transport container as
the transport container will afford the best protection.