Siemens Hematek 3000 System - Page 27

3 Life cycle
Hematek
®
3000 System – Instruction Manual – Version 1.3 93
3
3. In the pocket at the rear of the slide stainer, screw in the knurled thumb
screw retained with the transport container. If you have lost the knurled
thumb screw, order from the current Siemens product catalog or contact
the Siemens service
4. At the front of the system, apply adhesive tape to secure the waste tank
and slide drawer as displayed in Figure 3-2.
5. Remove the middle cover from the system.
6. Place the thin foam sheet retained with the transport container over the
pump assemblies.
7. Set the middle cover back in place securing the foam sheet and close
the lid.
1 Lid
2 Knurled thumb screw
3 Middle cover
4 Adhesive tape
5 Leveling feet
6 Slide drawer
7 Waste tank
8 Pump assemblies
Figure 3-2 Preparing the system for transport
5
5
1
2
3
4
7
6
8