Hematek
®
3000 System – Instruction Manual – Version 1.3 134
The Hematek Stain Pak - Modified Wright’s Stain contains a polychrome
methylene blue-eosin stain and specially prepared buffer and rinse. The
Hematek Stain Pak is contained in a single carton that fits easily into the
pocket at the rear of the slide stainer and requires no additional preparation
and opening. Each Hematek Stain Pak contains sufficient fluids to stain
approximately 750 to 1000 glass slides depending on the user-defined
settings for rotating speed of the pumps, which will determine stain usage.
4.2.2 Hematek Stain Pak - Wright-Giemsa Stain
A Hematek Stain Pak - Wright-Giemsa Stain is displayed in Figure 4-14.
The Hematek Stain Pak - Wright-Giemsa Stain contains a modified
polychrome methylene blue-eosin stain based on the original stain
proposed by Romanowsky. Also supplied are buffer and rinse. The
Hematek Stain Pak is contained in a single carton that fits easily into the
pocket at the rear of the slide stainer and requires no additional preparation
and opening. Each Hematek Stain Pak contains sufficient fluids to stain
approximately 750 to 1000 glass slides depending on the user-defined
settings for rotating speed of the pumps, which will determine stain usage.
4.2.3 Hematek Cannula Set
A cannula is displayed in Figure 4-15.
The Hematek Cannula Set contains three cannulas. The cannulas are
inserted into the Hematek Stain Pak bottles and connected to the stain,
buffer, or rinse tubes.
Figure 4-14 Hematek Stain Pak - Wright-Giemsa Stain
Figure 4-15 Cannula
To Next Page
Loading...
