Hematek
®
3000 System – Instruction Manual – Version 1.3 3TOC
6.2 Cleaning the exterior surfaces 6-2
6.3 Cleaning the stain tube and cannula 6-2
6.4 Cleaning the platen 6-4
6.5 Cleaning the waste tank 6-5
6.6 Cleaning the drain troughs and the rear guide rail 6-6
7 Performing maintenance 7-1
7.1 Periodic maintenance 7-1
7.2 Installing the Hematek Stain Pak 7-1
7.3 Replacing the pump tubing 7-3
7.3.1 Removing the pump tubing 7-3
7.3.2 Installing the pump tubing 7-6
7.4 Replacing the underplaten tubing 7-8
7.4.1 Removing the underplaten tubing 7-8
7.4.2 Installing the underplaten tubing 7-13
8 Troubleshooting 8-1
8.1 Troubleshooting chart 8-1
8.2 Leveling the system 8-4
8.3 Checking the adjustment of the sensing switch fingers 8-5
8.4 Adjusting the sensing switch fingers 8-6
8.5 Adjusting the pump volumes 8-8
8.5.1 Checking the staining process 8-8
8.5.2 Correcting the pump volumes 8-9
8.5.3 Verifying the pump volumes 8-11
8.5.3.1 Recorded volumes fall within specified ranges 8-14
8.5.3.2 Recorded volumes do not fall within specified ranges 8-15
8.6 Replacing the line fuses 8-15
To Next Page
Loading...
