Usi ng a different te lephone i n the same wa y as your own
67
6767
67
Step by Step
Identification with the chip card
Precondition: You have been assigned a chip card by
System Support for logon at other telephones. The
optiPoint 500 at which you wish to log on must be
equipped with a chip card reader (optiPoint 500 signa-
ture module).
Within your own HiPath 4000 or Hicom 300 E/H sys-
tem:
Insert the chip card. All lamps light up briefly.
"ID card" and the number of the home station are indi-
cated on the display.
or At another HiPath 4000 or Hicom 300 E/H sys tem in
the integrated network:
Insert the chip card.
E
Enter the node code for your own HiPath 40 00 or Hi-
com 300 E/H system (check with System Support).
EG Enter your own number and press the pound key.
Deactivating identification at the other
telephone
If you logged on with a PIN:
Press the key. The lamp lights up.
?? Enter the service code.
or
Select and confirm.
Select and confirm.
If you logged on with a chip card:
Remove the chip card when the telephone is in the idle
state.
Insert
chip card
Chip card
reader:
Ente r the code!
Service Menu
PIN / COS?
Deactivate PIN?
Identific ation is d eactivated automatica lly if the
other telephone is not used for several minutes.
Remove
chip card
Chip card
reader:
To Next Page
Loading...
