Step by Step
Programming an External Line
38
or Activate or deactivate polarity reversal on an external
line:
= To activate
= To deactivate (default)
Enter the number for the next external line available
or
Press this key.
Initial state for Programming Mode.
Dial Tone Detection
If Dial Tone Detection is activated on an analog line, the
number dialed will be stored and will only be sent to the
external line after the extension detects a dial tone from
the local carrier. With MF telephones the number dialed
will be transmitted to the external line approximately 4
to 5 seconds after the last digit was dialed (1A dialing).
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
Enter a number for an external analog line (e.g., 801).
or Activate/Deactivate Dial Tone Detection for an external
analog line:
= To activate (default)
= To deactivate
Enter the number for the next external line available.
or
Press this key.
Initial state for Programming Mode.
*
#
*
#
#
When using the GROUND option for Canada,
this feature must be disabled for external lines.
6 0
*
#
*
#
#
To Next Page
Loading...
