208/245
Building Technologies Division Basic Documentation LME7... CC1P7105en
Infrastructure & Cities Sector 25 Operation via internal LED 29.11.2011
25.4.4 Display of flame current QRB... or QRC...
Note:
This display is only possible in operating mode or standby!
-
LCD Bild 12/0908
Press
-
for display of the flame signal amplifier.
Signal lamp blinks green.
Display shows FL.2.
-
1...3 s
When pressing
-
(1…3 seconds), the flame signal
current is displayed.
Signal lamp blinks green.
Example: 1.1
-
>3 s
When pressing
+
(>3 seconds), the point after the
number begins to blink.
When the button is released, the value is displayed for 2
minutes.
Signal lamp blinks green.
Then, the normal display appears.
Display: Point . blinks, value 11 does not.
To Next Page
Loading...
