Siemens MC60 - Advanced Call Divert Settings; Setting Up Unanswered Divert; Configuring All Calls Divert; Divert Conditions (Not Reachable, Busy)

right page (65) of MC60 Maguro en, A31008-H5760-A1-1-7619 (21.10.2003, 14:59)
©
Siemens AG 2003, L:\MC60_Maguro\en\fug\_von_itl\MC60_fug_EN_031009\MC60_fug_EN_031009_FM\MC60_Setup.fm
65Setup
VAR Language: English; VAR issue date: 16-Juli-2003
Set up call divert (example):
The most common condition for call
divert is, for example:
Unanswered
b
I
Select Unanswered.
(Includes the conditions
Not reachable, No reply,
Busy, see below)
§Select§ Press.
Set Select.
J
Enter the phone number
to which the caller will be
diverted (If not already
entered)
Or
· Select this phone number
from the Phonebook or
via §Mailbox§.
§OK§ Confirm. After a short
pause, the setting is
confirmed by the network.
All calls
b
All calls are diverted.
n Symbol in the top line of
the display in standby
mode.
Not reachable
Divert occurs if phone is switched off
or is out of range.
No reply
A call is only diverted after a delay
that is determined by the network.
The period can be set to a maximum
of 30 seconds in 5 second intervals.
Busy
Divert occurs if a call is in progress. If
Call waiting is activated (p. 64), you
will hear the call waiting tone during
a call.
Receiving fax
b
Fax calls are diverted to a number
with a fax connection.
Receiving data
b
Data calls are diverted to a phone
number with a PC connection.
Status check
You can check the current divert
status for all conditions.
After a short pause, the current
situation is transmitted by the
network and displayed.
p Condition set.
o Not set.
s
Display if status is
unknown (e.g. with
anewSIM card).