2.2 System features
Configuration
Operator controls:
● Mechanical short-stroke keys
● Operating mode and function keys:
– 50 keys with assigned LEDs, of which 17 freely assignable customer keys in the
standard assignment
– Direction keys for milling machines with rapid traverse override
(The key covers for the direction keys for turning machines are supplied, see Section
Front side (Page 25))
● Spindle control with spindle override (rotary switch with 16 positions)
● Feed control with feed rate / rapid traverse override (rotary switch with 23 positions)
● Keyswitch (four positions and three different keys)
● Emergency stop button, two contact blocks (one NO contact + one NC contact each)
Interfaces:
● Two Ethernet interfaces (transmission rate: 10/100 Mbit/s; for IE and PN)
● Nine customer-specific inputs (e.g. for illuminated pushbuttons)
● Six customer-specific outputs
● Connection for two handwheels (Sub-D)
Velocity input and contour handwheel are only possible when connecting via the MCP PN
interface 6FC5303-0AF03-0AA0.
● Connection for one additional electronic override rotary switch
Expansion modules:
EM 66:
● When installed next to the MCP 398C, this results in a total width of 464 mm. The EM 66
is therefore suitable for use with the TOP 1900.
● Four 16 mm or three 22 mm slots (depending on the size of the switching elements).
● Space for the integration, for example, of pushbuttons, USB interface or other operator
controls.
EM 131:
● When installed next to the MCP 398C, this results in a total width of 529 mm. The EM 131
is therefore suitable for use with the TOP 2200.
● Six 16 mm or 22 mm slots (depending on the size of the switching elements).
● Space for the integration, for example, of pushbuttons, a USB interface, an Ethernet
interface, a handwheel, an additional override switch or other operator controls.
Description
2.2 System features
Machine control panel: MCP 398C
12 Manual, 12/2017, A5E43199783B AA
To Next Page
Loading...
