Pinyin phonetic spelling <TAB> Chinese characters <LF>
OR
Pinyin phonetic spelling <TAB> Chinese character1<TAB> Chinese character2 <TAB> …
<LF>
<TAB> - tab key
<LF> - line break
Store the created dictionary in one of the following paths:
../user/sinumerik/hmi/ime/
../oem/sinumerik/hmi/ime/
When the Chinese editor is called the next time, it enters the content of the dictionary into the
system dictionary.
Example:
2.4.13 Entering Korean characters
You can enter Korean characters in the input fields on classic panels (without touch operation)
using the input editor IME (Input Method Editor).
Note
You require a special keyboard to enter Korean characters. If this is not available, then you
can enter the characters using a matrix.
Introduction
2.4 User interface
Milling
60 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
