<END> + <SHIFT>
Moves the cursor to the last entry.
Selects a contiguous selection from the cursor position up to the end
of a program block.
<END> + <CTRL>
Moves the cursor to the last entry in the last line of the actual column
or to the end of a program.
<END> + <CTRL> + <SHIFT>
Moves the cursor to the last entry in the last line of the actual column
or to the end of a program.
Selects a contiguous selection from the cursor position up to the end
of a program block.
<BACKSPACE>
● Editing box
Deletes a character selected to the left of the cursor.
● Navigation
Deletes all of the selected characters to the left of the cursor.
<BACKSPACE> + <CTRL>
● Editing box
Deletes a word selected to the left of the cursor.
● Navigation
Deletes all of the selected characters to the left of the cursor.
<TAB>
● In the program editor, indents the cursor by one character.
● In the program manager, moves the cursor to the next entry to
the right.
<TAB> + <SHIFT>
● In the program editor, indents the cursor by one character.
● In the program manager, moves the cursor to the next entry to
the left.
<TAB> + <CTRL>
● In the program editor, indents the cursor by one character.
● In the program manager, moves the cursor to the next entry to
the right.
<Tab> + <Ctrl> + <Shift>
● In the program editor, indents the cursor by one character.
● In the program manager, moves the cursor to the next entry to
the left.
<CTRL> + <A>
In the actual window, selects all entries (only in the program editor
and program manager).
<CTRL> + <C>
Copies the selected content.
Introduction
2.2 Operator panel fronts
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 31
To Next Page
Loading...
Need help?
General
