1 2 3 4 5 6 7 8 9 10 Meaning
off off off off off off on on MCP address 192
x x x x x x x x "
on off off off off off off off MCP address 001
off off off off off off off off MCP address 000
You can find the settings for the basic PLC program in:
Function Manual, Basic Functions (P3 sl)
Switch S2
The handwheel signal type is set with switch S2-1.
Table 2-7 Settings of switch S2
S2-1 po‐
sition
Meaning
on Differential connection
off TTL connection
Switch S2-1 is set to "on" when delivered from the factory.
Note
S2-2 position
Switch S2-2 is reserved for test purposes.
See also
Pin assignment of the interfaces (Page 37)
2.3.3 Input / output images
Standard + two handwheels
The specifications for assigning input and output bytes listed in the tables can be changed in
the PLC via parameter assignment.
Note
The following applies in respect of the process input and output images in the tables: n is
defined by means of FB1 parameters in OB100 of the PLC.
Description
2.3 Interfaces
Machine control panel: MCP 398C
18 Manual, 12/2017, A5E43199783B AA
To Next Page
Loading...
