Hardware Installation
21
Building Technologies 048_DMS_NK8237_ICC_MP4.40_A6V10316241_a_en.doc
Fire Safety & Security Products 06.2011
Careful attention should be paid to the correct connections of Vac power lines.
Fig. 13 VAC power connection
Wires pass through 20mm (cut-out) holes* at the top of the cabinet (see Fig. 14),
and continu
e behind the cabinet to pass through the rear-side cavity to the en-
trance hole (see Fig. 15 and Fig. 16) where they should be anchored securely be-
fore bein
g connected to the screw terminators.
Fig. 14 Top view of NE8000 cabinet
When entering the metallic frame of the cabinet, wires should be protected by a
self-extinguishing plastic cord guard (UL94-V2 flammability rating).
(Not provided in the supply).
20 mm hole
cut-outs
Input VAC
1.5 mm
2
wires
To Next Page
Loading...
