Configuration
32
Building Technologies
048_DMS_NK8237_ICC_MP4.40_A6V10316241_a_en.doc
Fire Safety & Security Products 06.2011
7.2 Configuring IP settings via NW8202
This configuration must be performed before the NK8237 can be configured at the
client’s site. This procedure details how to send the IP configuration information;
that is, the IP address, Subnet mask, and Default address to the NK8237 via the
NW8202 Tool.
Note: This configuration procedure can be performed prior to shipping the NK8237
to the client, or at a later time at the client’s site.
1. Set the Service PC IP address to 192.168.9.1 and the subnet mask to
255.255.255.0.
a) Select Start Settings Network and Dial up Connections
b) Double-click Local Area Connection
c) Click the Properties button
d) Select Internet Protocol (TCP/IP)
e) Click the Properties button
f) Make note of the current IP address before replacing it with the new one
2. Click OK to restart PC when prompted.
3. Remove the cover of the NK8237 to be configured.
Press the 4 white tabs to the rear of the left and right sides of the unit and lift
gently.
4. Open the NW8202 application by selecting NW8202.exe located in
<InstallationDir>\Utilities\NW8202 folder
5. Select the Firmware Version NK823x.
6. Enter IP address, Subnet mask, and Default gateway in the corresponding
fields (see Fig. 23).
Fig. 23 NW8202 IP configuration download tool
7. Click Download
The Download Procedure window is displayed.
8. Follow the instructions displayed.
To Next Page
Loading...
