Siemens NXAIR M - Page 86

Operating the circuit-breaker panel with HV HRC fuse
86 NXAIR M 139-2021.9 / 07
Fig. 137: Detaching the low-voltage connector
Fig. 138: Removing the low-voltage
connector
Place the low-voltage connector (2) into the support located on the left side.
Fig. 139: Low-voltage connector placed on the left side
If no withdrawable circuit-breaker / fuse combination is inserted in the panel and no further
operation is executed: Close the high-voltage door.

The removed low-voltage connector is placed at the support located on the left side.
1
2
2