Approvals and Marks
6.2 c-tick
SIMATIC NET PROFIBUS, Optical Link Module
46 Operating Instructions, 07/2008, A2B00065774O, Edition V1.5
Installation guidelines
The products meet the requirements if you keep to the installation instructions and safety-
related notices as described in these instructions and in the “SIMATIC NET PROFIBUS
Networks” /1/ manual when installing and operating the device.
Conformity certificates
The EC Declaration of Conformity is available for the responsible authorities according to the
above-mentioned EC Directive at the following address:
Siemens Aktiengesellschaft
Bereich Automatisierungs- und Antriebstechnik
Industrielle Kommunikation (A&D SC IC)
Postfach 4848
D-90327 Nürnberg, Germany
Notes for the manufacturers of machines
The products are not machines in the sense of the EC Machinery Directive. There is
therefore no declaration of conformity relating to the EC Machinery Directive 89/392/EEC for
these products.
If the products are part of the equipment of a machine, they must be included in the
procedure for the declaration of conformity by the manufacturer of the machine.
General notice concerning the approvals
The listed approvals are valid only when the corresponding marks are shown on the product.
6.2 c-tick
Canada
Canadian Notice: This Class B digital apparatus complies with Canadian ICES-003.
Avis Canadien Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Australia
This product meets the requirements of the AS/NZS 3548 standard.
N117
To Next Page
Loading...
Need help?
General
