optiPoint 410 entry Administration
51
5151
51
Step by Step
Error Messages
The LEDs flash till you switch to the Administration
Mode Æ page 49.
LEDs on the phone: No IP address
The DHCP server cannot assign a terminal IP address
Æ page 80.
Possible solution
Check the DHCP server.
No terminal screen
The DHCP server cannot assign a terminal screen
Æ page 80.
Possible solution
Check the DHCP server.
No Default Route
The DHCP server cannot assign a default route
Æ page 68.
Possible solution
Check the DHCP server.
No IP Address is set
The DHCP IP assignment Æ page 69 is switched off
and no terminal IP address is configured.
Possible solution
Activate the DHCP IP assignment Æ page 16.
Enter the terminal IP adress Æ page 16.
To Next Page
Loading...
