Siemens OptiPoint 410 - Sylantro Functions; Using Call Forwarding; Call Forward on No Reply

Administration The optiPoint 410 Display Module
62
6262
62
The optiPoint 410 Display Module
LDAP configuration
The following preconditions must be fulfilled to use the corporate tele-
phone directory:
• An LDAP server is available and the server data is entered in the Dis-
play Module (see below).
• The LDAP template matching the server configuration was installed
Æ page 63.
The LDAP configuration area is protected against unauthorized access
through a password.
Configure LDAP server
To start the application, click the symbol on the start page.
Open the context menu and select "Server Settings".
Open the display keyboard and enter the administrator password.
Confirm.
Enter the IP No. and the Port for the LDAP server. The standard Port No. is
"389".
Save the configuration.
LDAP
abc
OK
C
?
Settings
abc
x
Save
Server Settings
137.128.15.230Server:
Port:
389|
IP address of the LDAP server
Port No. of the LDAP server
Save