Administration scenarios Setting up the FTP server
90
Check handset functionalities
• Check whether the plugs at the two ends of the handset cable are in-
serted correctly (handset engaged) Æ page 10.
• Carry out an Audio Loop test.
– More information on “Audio Loop Test“ Æ page 67.
– Æ page 41
• Ensure that the handset microphone is not switched off.
– For more information, see the operating instructions of the
optiPoint 410.
Start up not successful
Check whether one or more of the mentioned questions are valid for your
configuration:
Is the optiPoint 410 being run in a Æ VLAN ?
• Enter the VLAN ID manually, or, if a Æ DHCP server is being used, set
the “VLAN Discovery Mode“ Æ page 81 on "DHCP" , so that the VLAN
ID transferred from the DHCP server is used.
– More information on “Virtual LAN ID“ Æ page 81.
– Æ page 24 Æ page 59
Is the optiPoint 410 being run behind a Æ Gateway?
• Enter the Æ IP address of the Gateway in Æ Default Route.
– Æ page 21 Æ page 58
Other configuration possibilities ...
Check LAN connection
• Check whether the plugs at the two ends of the LAN cable are correct-
ly inserted (handset engaged) Æ page 10.
• Check the connection with the help of the PING test.
– More information on “PING Test“ Æ page 78.
– Æ page 42 Æ page 61
Determine the software version
You can determine the version of the software that is running the
optiPoint 410, e.g., during a pending software update.
• Æ page 39 Æ page 54
To Next Page
Loading...
