Siemens OptiPoint 410 - Line Settings; Activate;Deactivate Show in Overview for Multiline optiPoint display module; Position of Line in Multiline Overview Display Module; Showing Line Status in Call Information Box

Description of functions Alphabetical Reference
81
Time Zone Offset
• Make an entry here only if an Æ SNTP server provides time zone infor-
mation.
• The specification describes the shift in hours corresponding to the time
zone information of the SNTP server.
• Standard value Æ page 95.
• Integer editor in optiPoint 410 Æ page 94.
Æ page 37 Æ page 60
Upload Configuration
• Use this function to load (back up) an optiPoint 410 configuration on the
Æ FTP server.
• The following parameters must be set before the upload operation:
– Æ Download Server Address, Æ FTP Path, Æ Configuration Filena-
me
– Æ FTP account Name
– Æ FTP Username, Æ FTP Password
• Quick entry into the optiPoint 410 Æ page 103.
Æ page 60
Upload/Download Status
• “File Transfer Status“ Æ page 71
Virtual LAN ID
• Can be defined only if the Æ Layer 2 support is activated (Æ QoS L2/
L3).
• Enter a value from 0 to 4095 here. This value describes the association
with a certain VLAN, if a Æ VLAN is used.
Æ page 24 Æ page 16 Æ page 59
VLAN Discovery Mode
• Can be defined only if the Æ Layer 2 support is activated (Æ QoS L2/
L3).
• Here you must define the location from where the Æ Virtual LAN ID
should be fetched, if Æ VLAN is used.
Æ page 24 Æ page 16 Æ page 59
Manual The ID entered in Æ Virtual LAN ID is used.
DHCP If a Æ DHCP server is used, then the ID delivered by
this server is applied.