Wiring
6
30 | 34 A6V11571319_en--_b
NOTICE
Incorrect polarity and contact stability
Defective module or open line.
Take note of the positive and negative terminals when connecting to the Loop
isolator (100V).
Only connect one wire to each terminal.
4. Use cable ties to secure the cables to the Loop isolator (100V).
5. If no loudspeaker is connected directly to the SP terminals of the Loop isolator
(100V), see Chapter 4.1 [➙ 15], Fig. 3.
See also
Pin assignment, line and loudspeakers [➙ 21]
Topologies [➙ 17]
To Next Page
Loading...
