Siemens ProtoAir FPA-W44 - 9.2.1 Update Wired Network Settings; Figure 21: FS-GUI Ethernet Port Network Settings

Siemens ProtoAir Start-up Guide
Page 27 of 66
9.2.1 Update Wired Network Settings
IP Settings tab is the landing page when selecting Network Settings on the navigation tree. To change the
IP settings, follow these instructions:
• Enable DHCP Client State to automatically assign IP Settings or modify the settings manually as
needed, via these fields: IP Address, Netmask, Default Gateway and Domain Name Server1/2.
NOTE: If connected to a router, set the Default Gateway to the same IP Address as the router.
• Click Update IP Settings, then click on System Restart to restart the Gateway and activate the new
IP Address.
• Connect the ProtoAir to the local network or router.
NOTE: If the FS-GUI was open in a browser, the browser will need to be pointed to the new IP
Address of the ProtoAir before the FS-GUI will be accessible again.
IP Setting Fields
Definition
Connection Status
Status of connection
MAC Address
Ethernet MAC Address
Tx/Rx Msgs
Number of transmitted and received messages
Tx/Rx Msgs Dropped
Number of unanswered Tx or Rx messages
Figure 21: FS-GUI Ethernet Port Network Settings