Siemens ProtoAir FPA-W44 - Update Wi-Fi Client Settings

Siemens ProtoAir Start-up Guide
Page 28 of 66
9.2.2 Update Wi-Fi Client Settings
From the FS-GUI Network Settings landing page, click on the Wi-Fi Client tab. To change the Wi-Fi client
settings, follow these instructions:
• Set the Wi-Fi Status to ENABLED for the ProtoAir to communicate with other devices via Wi-Fi.
• Enter the Wi-Fi SSID and Wi-Fi Password for the local wireless access point.
• Enable DHCP to automatically assign all Wi-Fi Client network settings or manually modify the
setting using the fields immediately below (IP Address, Network, etc.).
NOTE: If connected to a router, set the IP gateway to the same IP Address as the router.
• Click Update Wi-Fi Settings, then click on System Restart to restart the gateway and activate Wi-Fi
Client settings.
• Go to Common settings (Section 9.2.3) to set the Primary Connection to Wi-Fi Client.
Wi-Fi Client Fields
Definition
Connection Status
Status of connection
MAC Address, BSSID, Channel
Wi-Fi Client MAC Address, BSSID, and Channel
Tx/Rx Msgs
Number of transmitted and received messages
Tx/Rx Msgs Dropped
Number of unanswered Tx or Rx messages
Pairwise Cipher
Type of encryption used for unicast traffic
Group Cipher
Identifies the type of encryption used for multicast / broadcast traffic
Key Mgmt
Encryption type
Link
Connection speed
Signal Level
Signal level in dBm (see Appendix A.6)
Figure 22: FS-GUI Wi-Fi Client Network Settings