Siemens ProtoAir FPA-W44 - 9.2.3 Common Settings; Figure 23: FS-GUI Common Network Settings

Siemens ProtoAir Start-up Guide
Page 29 of 66
9.2.3 Common Settings
From the FS-GUI Network Settings landing page, click on the Common tab.
NOTE: Default is Primary Connection is Ethernet.
To change the primary connection when both Ethernet and Wi-Fi Client connections are available:
• Select the desired option from the drop-down menu on the right.
• Click Update Common Settings, then click on System Restart to restart the gateway and activate
the new settings.
NOTE: If using Wi-Fi Client and not Ethernet, change Primary Connection to Wi-Fi.
NOTE: The fields below the update button show the settings as they were set in the IP Settings or
Wi-Fi Client pages. They are not editable on the Common page.
Figure 23: FS-GUI Common Network Settings