Parameter: Gateway Address
•
Default Setting: 0.0.0.0
This is the IP address of the gateway. It is required whenever an address outside the LAN of the station is
to be accessed. It can be set during device parameterization for a stand alone device and can also be set
in the IEC 61850 System Configurator when the device is associated with a station.
The Ethernet modules can be operated optionally with or without integrated switch function. This applies
for the electrical as well as the optical module. This function can be selected via the parameterization. It
is not necessary to make any indication in the order.
Parameter: Operating Mode
•
Default Setting: Line
The interfaces on the devices can be used in different operating modes. A distinction is drawn between
the operating modes Line and Switch.
[sc_7SR5_EthernetParametersOperatingMode, 1, --_--]
Device Functionality
3.7 Data Communications
Reyrolle 7SR5, Transformer Protection Device, Device Manual 125
C53000-G7040-C015-1, Edition 11.2019
To Next Page
Loading...
