Siemens Reyrolle 7SR5 - Page 43

i
i
NOTE
Hand reset LEDs can be reset by:
•
Pressing the ▶ key for ≥ 3 seconds when the home screen is displayed
•
Energizing a suitably programmed binary input
•
Sending an appropriate command over the data communications channel(s)
LCD
The structure of the device menu system is summarized in the following table. Note that the table shows
typical information available but depends on device functionality:
Home screen Mimic diagrams and device instruments can be configured in the Reydisp software tool
and displayed on the home screen. See the Operating manual for full details.
Settings Configuration Device (see
3.2 Device Configu-
ration )
CT/VT (see 3.3 CT
and VT Inputs )
Binary inputs (see
3.4 Binary Inputs )
Binary outputs (see
3.5 Binary Outputs )
Maintenance Output matrix test
Data storage (see
3.6 Data Storage )
Demand/data log
Waveform storage
Fault storage
Event storage
Communications
(see 3.7 Data
Communications )
Quick logic (see
3.8 Quick Logic )
Functions (Function
Template)
Function config
Protection <Fnct group> Function element 1
Function element n
<Fnct group> Function element 1
Function element n
Supervision <Fnct group> Function element 1
Function element n
<Fnct group> Function element 1
Function element n
Control <Fnct group> Function element 1
Function element n
<Fnct group> Function element 1
Function element n
Device Functionality
3.1 Device Fascia
Reyrolle 7SR5, Transformer Protection Device, Device Manual 43
C53000-G7040-C015-1, Edition 11.2019