Instruments Favourites
Current
Voltage
Frequency
Power
V/f meters
Thermal
Differential meters
Maintenance
Transformer meters
Miscellaneous
General alarms
Demand
Binary inputs
Binary output
Virtual
Comms
Quick logic
Control mode CB 2: Open/Close
CB 3: Open/Close
EF: In/Out
GS: In/Out
Set Local or Remote
Set Remote
Set Local
Device information Relay identifier
Circuit identifier
MLFB
Serial number
Firmware version
Comms FW version
Config version
Config capacity
Home Screen(s)
Up to 5 home screens can be configured using the Reydisp software tool.
Settings
Parameter changes can be entered from the device fascia. These can be for the Function Groups (FG) or
Function Elements (FE) i.e. the Settings > Function menus. 4 settings groups are provided for each
function – Group number (Gn) 1 to 4.
NOTE
Where the Setting Confirmation ID has been enabled this must be entered to allow changes.
At any 1 time only 1 group of settings can be active – Device Config > Active Group setting, (see
3.2 Device Configuration ).
Settings data is stored in non-volatile memory in the device.
Device Functionality
3.1 Device Fascia
44 Reyrolle 7SR5, Transformer Protection Device, Device Manual
C53000-G7040-C015-1, Edition 11.2019
To Next Page
Loading...
