[dw_7SR5_7SR5431ApplicationTemplate, 1, en_US]
Figure 2-9
Application Templates for 7SR5431 Devices
Default Function Template
The Default Function Template is the functionality included in the device when delivered from the
factory.
The RDM2 settings tool is used to add or remove Function Groups and Function Elements from the
Default Function template. Customization of the Default Template is typically carried out during the
engineering or installation phase of the project, prior to commissioning of the device.
Using the RM2 > Tasks > Device Functionality feature.
Default RM2 function templates are offered for selection automatically when a new device is created in RM2.
Custom Function Template
To ensure that the device functionality is viewed clearly and to facilitate parameterization it is recommended
that the user compiles a customized function template (CFT) in the RM2 tool.
The CFT need only include the functionality that will be used by the application and typically includes only a
part of the total functionality available in the device.
Optimization of the CFT will provide a clear minimized device/user interface.
All required function elements are selected from the Reydisp device Function Template.
When a function is initially installed the default settings of that function are applied.
Basic Structure of the Device Functionality
2.3 Function Groups and Function Elements
32 Reyrolle 7SR5, Transformer Protection Device, Device Manual
C53000-G7040-C015-1, Edition 11.2019
To Next Page
Loading...
