Siemens RUGGEDCOM RMC20 - Page 17

Installing the Device
2.3.1Mounting the Device on a DIN Rail
Removing the Device
To remove the device from a DIN rail, do the following:
1. Insert a flathead screwdriver into the slot of the sliding release and move it
down.
1
1
2
1
2
3
1
DIN Rail
2
DIN Rail Adapter
Figure2.2 Removing the Device from a DIN Rail
2. Swing the bottom of the device away from the DIN rail.
3. Lift the device off the DIN rail.
8
RUGGEDCOM RMC20
Installation Manual, 04/2021, C79000-G8976-1007-10